For best results, ensure the sensor on the front of the unit is not obstructed. How far away can you be from the sensor for it to still work? The sensor works best when motion is within 1.5 meters (5 feet). A concentrated burst of fragrance is released with each spray. Canister should be placed on top of the tan pull tab (pull tan tab when replacing refill for easy removal.) Pull the red strip from the battery compartment, position unit upright on a flat surface and the motion sensor does the rest. How does Glade® Sense & Spray® Air Freshener work? The unit comes with 2 AA batteries and a mini aerosol. It is a battery operated device with a built-in motion sensor and concentrated mini-aerosol spray refill. What is Glade ® Sense & Spray ® Air Freshener? Glade ® Sense & Spray ® Air Freshener is a motion activated air freshener. Open the front cover and insert 2 new AA batteries by matching positive and negative signs. Lay refill canister into position over than refill tab and snap into place. Make sure lever is pushed fully up before inserting new refill.Ĥ. Pull tan refill tab to remove refill canister.ģ. Sensor on the front of the device is blocked by objects: position the unit so that the sensor is unobstructed.Ģ. The unit is placed directly under a light, especially sunlight: move the unit out of the bright light. The room is too dark: ensure sufficient lighting to allow a shadow to be cast upon the sensor. Place unit within 1.5 meters (5 feet) of traffic flow. Place assembled unit on a flat surface where upward spray will not be obstructed. Use only Glade® Sense & Spray® refills in Glade® Sense & Spray® starter units. For an instant burst of fragrance anytime, press the boost button on the front of the unit. After the 20 minute lockout, the unit is in active mode and ready to detect motion. After the unit has sprayed, in order to conserve the refill, the sensor will turn off automatically, indicated by the light flashing once every 3 seconds, and will not spray for 20 minutes. The light will blink rapidly for 3 seconds to warn when it is about to spray. The unit automatically sprays fragrance when a shadow has been cast upon the sensor. Pull and discard red tab to activate batteries. The unit will then begin sensing motion.Ģ. It automatically sprays a burst of fragrance 5 seconds after assembly to show it is working properly. CAUTION: Keep the unit pointed away from you and others during assembly.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |